December 2001: Scientific Journal Describes ‘Eutectic Mixture’ in WTC Steel

The Journal of the Minerals, Metals and Materials Society (JOM) reports that the examination of a beam from the remains of WTC Building 7—which collapsed late in the afternoon of 9/11 (see (5:20 p.m.) September 11, 2001)—has revealed “unexpected erosion” of the steel. The article states: “The formation of the eutectic mixture of iron oxide and iron sulfide lowers the temperature at which liquid can form in this steel. This strongly suggests that the temperatures in this region of the steel beam approached around 1,000°C, forming the eutectic liquid by a process similar to making a ‘blacksmith’s weld’ in a hand forge.” [Barnett, Biederman, and Sisson, 12/2001] The New York Times will call this “perhaps the deepest mystery uncovered in the investigation.” [New York Times, 2/2/2002] FEMA’s World Trade Center Building Performance Study, released in May 2002 (see May 1, 2002), will add that the same “unusual erosion patterns” have been observed in a sample of the remaining structural steel from one of the Twin Towers. It will state, “This sulfur-rich liquid penetrated preferentially down grain boundaries of the steel, severely weakening the beam and making it susceptible to erosion.” FEMA is unable to explain this phenomenon, saying, “The severe corrosion and subsequent erosion… are a very unusual event. No clear explanation for the source of the sulfur has been identified.… It is possible that this is the result of long-term heating in the ground following the collapse of the buildings. It is also possible that the phenomenon started prior to collapse and accelerated the weakening of the steel structure.” [Federal Emergency Management Agency, 5/1/2002, pp. C-1 – C-13] Despite FEMA’s call for further research, the National Institute of Standards and Technology (NIST) will make no mention of the eutectic formations in its final report into the WTC collapses, released in late 2005, following its three-year investigation. [National Institute of Standards and Technology, 9/2005, pp. 13]