August 27, 2003: NIST Investigators Rule Out Weak Steel as a Factor in Collapses

At the end of a two-day meeting to discuss the progress of their investigation of the WTC collapses on 9/11, National Institute of Standards and Technology (NIST) investigators say that early tests on steel beams recovered from the World Trade Center showed they met or were stronger than design requirements. NIST has collected 236 pieces of steel from the wreckage of the towers. Tests have found that the steel beams exceeded requirements to bear 36,000 pounds per square inch, and were often capable of bearing around 42,000 pounds per square inch. Lead investigator Shyam Sunder says that if further testing corroborates these findings, this will rule out weak steel as a factor in the collapses. [National Institute of Standards and Technology, 8/26/2003; Associated Press, 8/28/2003] The final report of the NIST investigation, released in 2005, will corroborate this finding: “Overall, approximately 87 percent of all perimeter and core column steel tested exceeded the required minimum yield strengths specified in design documents. Test data for the remaining samples were below specifications, but were within the expected variability and did not affect the safety of the towers on September 11, 2001.” It also will point out: “Of the more than 170 areas examined on 16 perimeter column panels, only three columns had evidence that the steel reached temperatures above 250°C.… Only two core column specimens had sufficient paint remaining to make such an analysis, and their temperatures did not reach 250°C.… Using metallographic analysis, NIST determined that there was no evidence that any of the samples had reached temperatures above 600 °C.” [National Institute of Standards and Technology, 9/2005, pp. 89-90]